Great little tool 
This is a great tool for cutting metal. Works as well as expected. Requires few adjustments. Just setup and go. I really like mine.
Could be better 
Problems on assembly:
1) Center hole on cast iron base @ both ends was not centered + did not line up to the leg cross brace. Fix: used air grinder to grind cross brace hole wider.
2) Instructions for the installing the adust. feet were vague. Just says use "provided hardware". Fix: used my incredible powers of observation and deduction to determine what goes where.
3) The leg cross brace opposite of motor has an interference problem w/switch box. Fix: ground the cross brace to form a notch to clear switch box.Usage:
1) table for vertical cuts is flimsy. Only single support underneath - needs 2. could not level table since there is no adjustment.
2) Adjustment of eccentric bearing requires a thin wrench to fit between bearing + support casting.
3) The blade covering has to be put on "just right" otherwise interference with the stop bolt occurs.
4) When moving the miter vise plate, the hold down bolt interferes w/the screw that holds the scale strip. Loosening the bolt enough will get past the interference unless the angle you want is right where the interference occurs.
In general:
The motor has enough power for cuts. I've been cutting 4130 .125 steel and the motor never bogged down. Horizontal cuts is this machines best use. vertical cutting leaves a lot to be desired but this could be because the blade's tooth pitch did not match up to the metal type. But,as stated above, the table doesn't help.
Great little timesaver!
I'm not a home improvement enthusiast. Don't know why Amazon put that there. (Stupid!) I'm a hobby machinist.I compared several different Asian made 5x6 bandsaws. Don't believe it when someone tells you they're all the same.
The Jet was very easy to assemble and use. Very solid base. UL approved motor that is bigger than some other bandsaws have. Nice fit-and-finish.
Some other ones I checked on needed to have additional bracing added due to a flimsy base. I had read about some of the others having motors prone to overheating and meltdown.
Bought mine locally for $249.99. Don't understand how Amazon can charge a $70 premium. Around $250 seems to be everyone's prices except Amazon. $319.99! Ridiculous!
Very nice saw
I looked at the grizzly and harbor frieght saws and then I saw a jet saw at my job,abviously heavier duty. But what i had noticed about the jet saws is they are more stockier build and heavier construction.I went to harbor frieght and the cover on the 4 by 6 was broken.I set this saw up in no time and had no troubles it cuts very nicely and timely,I am very pleased with it.
