A benchtop router offers significant advantages over a handheld machine. It's safer, because you're moving the wood over the bit instead of the other way around. It's also versatile, allowing you to do a number of cuts that aren't possible with a handheld. And because it has a fence, it gives you a degree of control and precision that is simply impossible with freehand routing.Because you're sliding the wood across the surface of a bench router, it's important that the surface be as frictionless as possible. The RA1181 features a generous 27-inch long by 18-inch wide table that's made out of slick but durable cast aluminum. In addition, he surface near the fence is rough-ground to minimize surface contact, which further reduces friction.
Though the caveat "some assembly required" applies here, the manual is clearly written, and I found the setup process to be straightforward. Once fully assembled, the RA1181 attaches to just about any workbench via the leg assemblies, which have flat "feet" that you can clamp to the table. You can also use the pre-drilled holes to screw it to your work surface if you don't need it to be portable. (Note that most benchtop routers need to be mounted on a smaller table-using a standard worktable may leave it uncomfortably high.)
Once secured to the table, the RA1181 is very stable, and can handle high-horsepower routers and larger work pieces without bucking. The cast aluminum mounting plate accepts a variety of routers-and not just those made by Bosch. The fence is good and rigid, and is adjustable from 0 to 3-3/4-inches wide.
This is a great little machine, and its portability and capacity for bigger jobs makes it as good a fit on the job site as it is in the home workshop.--Josh Dettweiler
What's in the Box
Two adjustable featherboards, three mounting plate insert rings, one adjustable clear guard, one starter pin and guard, two outfeed fence shims (1/16-inch thick), appropriate router mounting hardware
